9
Getting Started
Charging the battery pack
a. Insert the small plug in the end of the mains adaptor into the Power-in
Connection Jack at the back of the desktop charger.
b. Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on
the socket set to OFF.
c. Switch ON the main socket.
The radio must be charged using the mains adaptor provided. Using any
other adaptor will invalidate any approvals & warranty.
d. Place the radio units in the charge cradle in an upright position and facing
outward.
The Charge LED indicators will light up.
e. It takes about 10 hours to fully recharge the batteries if the battery are
completely run down.
New batteries take up to 14 hours to fully charge.
Important
Read these Safety Warnings before you charge the
batteries.
When placing the radio in the charger,
use only the power
supplies listed in the user instructions supplied with the unit.
Don’t try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely
locked in place
when you are charging the batteries.
Dispose of used batteries safely and in a way that will not
harm the environment-
never try to burn them or put them
anywhere, they could get burnt or punctured.
Don’t leave dead batteries in your radio.
They might leak if you do.
Main socket
Important:
Always turn off the radio units when charging.
This will shorten the charging time.
Summary of Contents for PMR1200
Page 1: ...Operating Instructions PMR1200 40 Channel UHF 2 Way Citizen Band Radio...
Page 2: ......
Page 27: ......
