10
Getting Started
Charging batteries
When NiMh battery packs are installed, the desktop charger
provides drop-in charging convenience.
1. Put the desktop charger on a flat surface.
2. Plug the supplied adaptor into the electric socket. Pay
attention to the mentioned voltage and compare this with the
indications of the power supply. Connect the low tension plug
at the end of the cable with the connector on the backside of
the desktop charger.
3. Put the radio in the charger as indicated.
4. The charging LED will turn on if it’s properly inserted and charging.
It will take about 12 to 14 hours to fully charge the batteries. There is
no indication on the display when the batteries are being charged.
Note:
Use only power supplies
KEAD-223-A (SSA-5W-09 EU 090020F)
Note: The device can also operate with 3 x AAA NiMh batteries
or with 3 x AAA Alkaline batteries. But they cannot be charged
with the charger.
Battery Charge Level
The BATTERY CHARGE LEVEL is indicated by the number of
squares present inside the BATTERY icon on the LCD Display.
Battery Full
Battery 2/3 charged
Battery 1/3
charged
Battery empty
When the battery charge level is low, a beep will be heard.
