10
Getting Started
Charging the batteries (using charging pod) - PMR1290
a. Insert the small plug in the end of the mains
adaptor into the Power-in Connection Jack at the
back of the desktop charger.
b. Plug the mains adaptor into a 230V AC, 50Hz
mains socket with the switch on the socket set to
OFF.
c. Switch ON the mains socket.
The radio must be charged using the mains adaptor provided. Using any
other adaptor will invalidate any approvals & warranty.
d. Place the radio units in the charge cradle in an upright position and facing
outward.
The Charge LED indicators will light up.
e. It takes about 10 hours to fully recharge the batteries if the batteries are
completely run down.
New batteries will take up to 14 hours to fully
charge.
Charging the batteries (using USB adaptor) - PMR1295
a. Lift the charge socket cover located on the right
side of he handset.
b. Insert the USB connector of the 5VDC/600mA
adaptor into the charge jack.
c. Plug the mains adaptor into a 230V AC,50Hz mains
socket with the switch on the socket set to Off.
d. Use only the power supply provided.
e. Switch ON the main
s socket.
The radio must be charged using the mains adaptor provided. Using any
other adaptor will invalidate any approvals & warranty.
Charging the batteries (using USB adaptor) - PMR1290-1
a. Lift the charge socket cover located on the right side of he handset.
b. Insert the USB connector into any USB point for 12V/240V charging.
a. Slide down the Battery Compartment Cover.
b. Install the Rechargeable batteries (supplied) or Alkaline batteries (not supplied)
by following the orientation as shown in Figure 3.
c. Replace the Battery Compartment Cover. See Figure 4.
Mic/spk jack
Charge jack
