8
Getting Started
Installation
Removing the Belt Clip
Pull the belt clip latch away from the
radio.
While pulling the belt clip latch, push
up the belt clip as shown in Fig. 1.
Installing the Belt clip
Slide the belt clip into the slot as
shown in Fig. 2.
A “click” indicates the belt clip is
locked into position.
Belt clip latch
Figure 1
Figure 2
Figure 3
Figure 4
Installing the Batteries
Slide down the battery
compartment cover.
Insert the 3xAAA batteries
(not supplied). Position the
batteries according to the
polarity marking on the
battery compartment. See
Fig.3
Replace the battery cover.
See Fig. 4.
Notes:
• Use only same type and make of batteries in the unit.
• The radios have a built-in Power Saver mode (PS) for maximum battery life,
but when not in use, turn the units OFF to save battery power
• Remove the batteries if the units will not be used for a long period of time.
