15
Operation
Activating the Auto Channel Scan
Channel scan perform searches for active signals in an endless
loop for all 40 channels, 38 CTCSS codes and all 83 DCS codes.
a. Press the
MENU
button 5 times, “
SCAN
” icon will display
on LCD screen.
b. Press the
UP
or
DOWN
button to begin scanning
channels when an active signal is detected, channel scan
pauses on the active channel.
c. Press the
MENU
button six times, CTCSS flashes on
the LCD screen press the
UP
or
DOWN
button to begin
scanning the CTCSS from 1-38.
d. Press the
MENU
button seven times, DCS flashes on
the LCD screen. Press the
UP
or
DOWN
button to begin
scanning DCS code 1-83.
e. Press the
PTT
button to confirm your setting.
Vibrator and Call alert
Your radio can alert you to incoming signal by emitting an audible
call tone and vibration signal.
Call-Ring tone
You can send a Call-ring tone to other radio users to give
an alert that you want to communicate with them.
Press the CALL button
You will hear a ring tone for about two seconds; “
TX
” icon
appears on the LCD screen. Any other units within the
transmitting range and tuned to the same channel and sub-
channel (if applicable) will hear the Call-ring tone.