11
Getting Started
Mic/spk jack
Charge jack
Charging the batteries
(using adaptor) - UHF2195
a. Lift the charge socket cover located on
the right side of the handset.
b. Insert the round connector of the 9.0V
DC/500mA adaptor into the charge
jack.
c. Plug the mains adaptor into a 230V
AC, 50Hz main socket with the switch
on the socket set to Off.
d. Use only the power supplies listed in the user instruction.
Then switch ON the main socket.
Battery meter
The battery meter is located in the left corner of the LCD screen.
It appears like a battery with three bars inside. These indicate the
amount of power available. When the battery level reaches its
minimum level, the unit will emit two beep tones and automatically
it will power off.
Your UHF2190/2195 can detect the battery charge in 4
levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the radio will emit
a “beep” sound for every 10 seconds in standby mode.
TIP: At this stage, you need to recharge the unit at
once, otherwise the battery will run down totally.
Battery charge at very low level. When the battery level
reaches its minimum level, the unit will emit two beep tones
and automatically turn off the power.
Important: You need to charge the unit for 10-14 hours.
CAUTION: Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according
to the instructions.
OR011253 UHF2190_2195 User Guide_11-07-14.indd 11
2014/11/7 14:31:10
