15
Operations
Enabling CTCSS on a Channel
If a CTCSS tone has been selected, it can be enabled on individual channels.
1. Rotate the Channel knob to select the required channel. The letters "CT" will appear.
2. Press and hold the
MO/TSQ
button.
SC / MEM
MO/TSQ
ID/CAL
PRI/LO
F/ DPX
You may activate CTCSS on as many channels as you wish except channel 5
and 35 which are designated for emergency use.
Disabling CTCSS on a Channel
Repeat steps 1 and 2 above.
Note:
You will not be able to activate CTCSS if the CTCSS tone is set to ‘OFF’.
SCANNING
The radio SCAN function has the ability to allow programmable channels to be
scanned for activity on the channels.
Channels can be scanned (40 channels per 5 seconds). When a signal is found,
scanning will stop at that channel to allow the signal to be heard, then resume
scanning when the channel is clear again.
Scan Modes
The Radio features three scan modes - Open Scan, Priority Scan and Instant
Memory Scan.
Open Scan
The Open Scan feature scans for activity on all CB channels. Once a channel is
located, scanning will pause then will allow the signal to be heard. As soon as
the channel is clear for 5 seconds, scanning will continue automatically.
Open Scan
UHF380_manual.indd 15
2013-3-8 8:56:17
