12
Charging the Radio
Connect the socket of
the wall adaptor to a
mains power outlet and
insert the jack of the
wall adaptor into the
desktop charger plug
(see Fig. 1). It takes
approximately 3 hours
to fully recharge.
Place your transceiver
into the cradle of
the desktop charger.
The RED LED on the
charger will light up.
When charging is complete, take the transceiver out of the cradle and
detach the socket of the wall adaptor from the mains.
The red LED on the mains charger pod will change to green when
charging is complete. It will take approximately 3 hours to fully charge
the battery with the radio turned off.
You can also charge the radio using a 12V adaptor supplied. Plug the
adaptor into the 12V outlet in your car and insert jack into the desktop
charger (see Fig. 2).
Do not transmit when the ULTRA550
is in the charger pod.
The Belt Clip
1. Place the belt clip into the slot on the back of the
radio.
2. Then slide it down.
3. You will hear a click. The belt clip is firmly
installed.
Installation
Fig. 2
Fig. 1
Summary of Contents for ULTRA550
Page 35: ......
