The ambient
and water
temperature
The ambient and water
temperature is too low
Adjust the temperature.
Ice cubes size
The size is too big.
See “the adjust of ice cube size”.
The lines of the hot gas
valve loose.
12
Plug into again
Hot gas valve
Hot gas valve
performance poor or
break
Replace the coil of hot gas valve if
only because of the coil.
Refrigerant
Refrigerant leaks
Recharge
The
evaporator
is hot more
than 4
minutes
Electric control
box
The electric control box
is wrong
Check the control box
Adjustment and Replacement
Replace Control box, fuse and the sensor of temperature
¾
Remove the rear cover, front panel,
¾
Locate the Electronic control box,
¾
Pull out the sensors of temperature (one at the evaporator, another at the condenser).
¾
loosen the screws of rooting the Electronic controller, replace a new one. Reverse the above step
to replace.
¾
If you need replace the fuse, open the front panel of the control box, you will find the figure.
According the figure, take out the fuse, rep
Reverse the above step to reassemble.
If you need replace the sensors of temperature, pull out the sensor of temperature, open the panel
Adj
usted to bring the cubes to the correct shape, the overall size can't be
lace a new one.
¾
of the controller box, pull out the other side, replace a new one. Reverse the above step to
reassemble.
ust the size of ice cube
The cube size should only be adj
adjusted, Try to adjust the cubes size when the ice maker is work in the Ice Harvest Status.
1. Power off the icemaker.
ELECTRICAL SHOCK HAZARD
Disconnect Electrical Power Before
Beginning Removal of Parts
