PCB & Control Panel Details
Instructions for use of the remote control
1. When the remote control is used for the first time, please take out the insulation sheet from its back.
2. The scope of application of the remote control is within 5m from the receiver. If the remote control does
not face the receiver, its scope of application will be narrowed.
3. The remote control must face the receiver (the receiver is located in the product panel).
4. There shall be no barrier between the receiver and remote control.
5. The remote control may be out of order, if it is used in a room with high frequency machines (due to
electromagnetic interference, the sensitivity of the remote control will be reduced).
6. Please keep the remote control properly and do not impact or make it fall down.
Instructions for use of the electronic panel.
The electronic panel has the wind speed of three levels and three types of wind mode as well as the swing
and timing functions.
Power (On/OFF) switch key
: After the power supply is connected, press this key, the fan will be started
at a medium speed and work at a low speed, and the power button and wind speed button will light up.
Press this key again, all working states of the fan will be stopped and the button light will go out.
Wind speed regulating key: Under the startup state, press this key for selecting the wind speed needed.
Instructions for Use
Swing Key
: Press the swing key to turn on the swing function, the button light will glow; press it again
to stop the swing.
Timer key
: Press this key, the time of countdown required may be set and the timing button light will
light up.
Mode key
: Press mode key to switch between Normal – Natural – Sleep functions as per requirement.
Low speed
Medium speed
High speed
Natural wind
Sleep wind
Normal wind
ON
OFF
OFF
ON
0.5H will be increased after
pressing each time
Release
Swing
Normal Natural Sleep
Low
Electronic type
0 5h
.
1h
2h 3h
Middle High
