Installation
−9−
3.5 Actions to be taken upon detachment of the rack
If the rack detaches during installation or operation, take the following actions:
1.
Turn off the power and remove the load.
2.
With the
2LS
type, affix the gear and rack case using an adhesive tape, etc., so that the two will
not separate from each other.
3.
Remove the screws affixing the motor, and take out the motor.
4.
Insert the detached rack through the rack bushing.
Push in the rack until it comes out from the rack bushing on the opposite side.
5.
Assemble the motor by paying careful attention not to cause the rack to detach.
