6 Connection
－
27
－
Note
•
The CW and CCW inputs provided as driver input signals indicate the
opposite directions to the output table’s direction of rotation. When the
CW input is active, the output table rotates counterclockwise. When the
CCW input is active, the output table rotates clockwise.
•
Be certain the control input/output cable that connects the driver and
controller is as short as possible. The maximum input frequency will
decrease as the cable length increases.
•
Connection of 24 VDC
Either 5 or 24 VDC is selected as a signal voltage for the C.OFF input, ×10 input
and ACL input.
R
0
R
0
0 V
0 V
0 V
0 V
0 V
V
0
+24 V
0 V
0 V
CN3
11
CW input
12
CW input
9
CCW input
10
CCW input
3
Vcc+24 V
22
ACL input
32
×10 input
34
C.OFF input
25
ALARM output
26
ALARM output
29
END output
30
END output
23
TIM.1 output
24
TIM.1 output
15
ASG1 output
16
GND
13
BSG1 output
14
GND
Driver
Controller
+30 V or less
+30 V or less
Photocoupler input
5 VDC Input current 7 to 20 mA
Photocoupler input
24 VDC Input current 5 mA
Photocoupler/open-collector output
30 VDC or less
Output current 15 mA or less
Transistor/open-collector output
30 VDC or less
Output current 15 mA or less
Twisted pair cable
or shielded cable
Note
•
The CW and CCW inputs provided as driver input signals indicate the
opposite directions to the output table’s direction of rotation. When the
CW input is active, the output table rotates counterclockwise. When the
CCW input is active, the output table rotates clockwise.
•
The CW and CCW inputs are of the 5 VDC input specification. If V
0
exceeds 5 V, connect external resistor R
0
.
Example) When V
0
is 24 VDC R
0
: 1.5 to 2.2 k
Ω
, 0.5 W or more.
Summary of Contents for ASD10A-K
Page 51: ......
