5
Connection
Connecting the motor and driver
Connect the motor and driver using the connection cable (sold separately).
There are three types of connection cables which cable outlet directions are
different.
To driver
Connection cable
Motor
Check the operating manual
of the driver for how to
ground.
Cable outlet opposite
to output shaft direction
Cable outlet in output
shaft direction
[ Cable outlet direction ]
Cable outlet in
vertical direction
Cable outlet in output shaft direction
CC_____
F
CC_____
B
CC_____
V
Note
Use the connection cable that the label for electromagnetic
brake motor is attached. Failure to do so may result in damage to
equipment.
Label for electromagnetic
brake motor
For
BRAKE
MOTOR
Connection procedures of the motor and connection cable
The following example explains using the connection cable of "cable outlet in
output shaft direction."
1
Remove
2
Attach
3
Secure
The connector cannot be inserted
if the locking lever is turned down.
Be sure to turn down
the locking lever till
the position shown
in the figure.
Secure the connector by turning
down the locking lever completely.
Check the cable outlet direction and insert the connector securely.
Secure the cable with the locking lever so that the cable does not
come off.
Connector cap
Locking lever
Position of locking lever
Note
Do not lift up the product by
holding the connection cable.
Doing so may cause damage to
the product.
Detaching the connection cable
If the locking lever is turned up, the cable can be detached.
Up to two pieces of the connection cables for relay can be connected.
Check the operating manual included with the driver.
