Reference
−39−
13 Reference
13.1 Standard and CE Marking
This product is affixed the CE Marking under the Low Voltage Directive and EMC Directive.
Some products are recognized by UL under the UL/CSA standards. The name of products certified to conform with
relevant standards are represented by applicable unit model motor and driver part numbers.
Output power
Power supply voltage
UL/CSA Standards
CE Marking
KC Mark
200 W
Single-phase 100-120 V
－
○
－
Single-phase/Three-phase 200-240 V
○
○
○
400 W
Three-phase 200-240 V
－
○
－
UL Standards and CSA Standards
(200 W·Single-phase/Three-phase 200-240 V input type only)
Applicable Standards
Applicable Standards Certification Body Standards File No.
Motor
*
1
UL 1004-1
CSA C22.2 No.100
UL
E335369
Driver
*
2
UL 508C
CSA C22.2 No.14
E171462
*1
Thermal class UL/CSA Standards: 105(A)
*2
The driver is recognized by UL under the condition that the front panel side of the driver is installed in the front
direction. Installation direction → p.11
Low Voltage Directive
•
This product is designed and manufactured
to be incorporated in equipment.
•
This product cannot be used with cables
normally used for IT equipment.
•
Install the product within the enclosure in
order to avoid contact with hands.
•
Be sure to ground the Protective Earth
Terminal of the motor and driver.
•
Isolate the motor cable, power-supply
cable and other drive cables from the
signal cables (CN4) by means of double
insulation.
Applicable Standards
•
Motor: EN 60034-1, EN 60034-5, EN 60664-1
•
Driver: EN 61800-5-1
Installation conditions (EN Standard)
Motor
*
Driver
For incorporating in equipment
Overvoltage category:
Ⅱ
Pollution degree:
2 (for IP40 rated motor)
3 (for IP65 rated motor)
Protection against electric shock:
Class
Ⅰ
For incorporating in equipment
Overvoltage category:
Ⅱ
Pollution degree: 2
Protection against electric shock:
Class
Ⅰ
*
Thermal class EN Standards: 120(E)
EMC Directive
This product has received EMC compliance under the conditions specified
in "Example of motor and driver installation and wiring" on p.41. The final
level of conformance of your mechanical equipment to the EMC Directive
will vary depending on the control system equipment used with the motor/
driver, configuration of electrical parts, wiring, layout, hazard level, and the
like. It therefore must be verified through conducting EMC measures on your
mechanical equipment.
This type of PDS is not intended to be used on a low-voltage public network
which supplies domestic premises; radio frequency interference is expected if
used on such a network.
Applicable Standards
EMI
EN 55011 group1 class A
EN 61000-6-4, EN 61800-3
EN 61000-3-2
EN 61000-3-3
EMS EN 61000-6-2, EN 61800-3
A temperature test has been conducted
with a heatsink plate.
The size, thickness and material of the
heatsink plates are as table.
Motor model
Size
Thickness
Material
BLM5200
BLM6200
200×200 mm
(7.87×7.87 in.)
5 mm
(0.20 in.)
Aluminum alloy
BLM5400
BLM6400
250×250 mm
(9.84×9.84 in.)
6 mm
(0.24 in.)
Summary of Contents for BMU5200A Series
Page 43: ...43...
