7
Regulations and standards
UL Standards
Check the "APPENDIX UL Standards and CSA Standards for
RKII
Series" for
recognition information about UL Standards.
CE Marking
This product is affixed the CE Marking under the Low Voltage Directive.
•
Low Voltage Directive
Applicable Standards
EN 60034-1, EN 60034-5, EN 60664-1
Installation conditions
(EN Standard)
To be incorporated in equipment.
Overvoltage category: II
Pollution degree: 2
Degree of protection: IP20
Protection against electric shock: Class I
y
This product cannot be used with cables normally used for IT power
distribution systems.
y
Install the product within the enclosure in order to avoid contact with
hands.
y
Be sure to maintain a protective ground in case hands should make contact
with the product. Be sure to connect the Protective Earth lead of the cable
for motor to the Protective Earth Terminal on the driver, and ground the
driver's Protective Earth Terminal.
y
To protect against electric shock using an earth leakage breaker (RCD),
connect a type B earth leakage breaker to the primary side of the driver.
y
When using a circuit breaker (MCCB), use a unit conforming to the EN or IEC
standard.
y
Isolate the motor cable, power-supply cable and other drive cables from the
signal cables by means of double insulation.
y
The temperature of the driver's heat sink may exceed 90 °C (194 °F)
depending on the driving conditions. Accordingly, take heed of the
following items:
• Do not touch the driver.
• Do not use the driver near flammable objects.
• Always conduct a trial operation to check the driver temperature.
RoHS Directive
The products do not contain the substances exceeding the restriction values
of RoHS Directive (2011/65/EU).
