Explorer Collection™ Manual
(Unlocked)
Bayonet Ring
Push Tabs
Against Rail
Adjust the clips so that they’re positioned at the top of the rail. If they’re not al-
ready there you can do this by pushing the release tabs (or metal “buttons”) on
the inside of the rail and pulling the clips to the top of the rails. Insert the bayonet
ring into the hole in the ceiling by gently bending the clips inward. Reach inside
the bayonet ring and push the clips down so that the bayonet ring is firmly in
place, but not too tight. If for some reason the bayonet ring needs to be removed,
reach inside and push the release tabs to fully remove the clips. After the clips
have been removed, the bayonet ring can be taken out.
4. Installing the Bayonet Ring
coat hanger through the hole to feel around. Use a keyhole or drywall saw to cut the hole.
5. Connecting the Wire
10
To further maintain installation integrity, the
Explorer collection uses screw-down Phoenix
connector. Note the positive (+) and negative
(-) indicators on the connector and make wire
connections appropriate Ensure that the positive
wire is being attached to the positive connection
and the negative wire is being attached to the
negative connection. If the negative and positive
wires are switched, speaker performance will be
drastically impacted.
+
-
RED
BLACK
