STEP 2; SEE FIGURE 2:
Assemble Frame
A.
Connect the Front Bow Halves (6 & 7). Lay the Front Bow and Rear Bow (8) on a flat surface.
Place the ends of the front bow on the outside of the ends of the rear bow. Insert four bolts
outwards through the ends of the bows. Place the ends of the Top Bow (9) over the two forward
bolts of the assembly. Add two locknuts and tighten keeping the top of the center bow leaning
about 4” forward of vertical.
B.
Refer to the illustration to attach the Posts (3 & 4) and right and left Braces (5) to the
assembled frame. Do not tighten the bolts at this time.
C.
Insert the square ends of the posts into the receivers on the tractor. Tighten all bolts while
keeping the framework level.
D.
Slip the front of the Vinyl Cover over the front bow. Pull the rear of the cover down over the
rear bow. Push the center bow up to tighten the cover if needed.
6
8
NOTE:
Apply some wax to the square
ends of the posts to ease insertion and
removal of the Sunshade from the
receivers.
7
5
9
5
3
NOTE:
Use 1/4” x 5/8” bolts & 1/4”
lock nuts unless specified otherwise.
Arrows indicate bolt direction.
4
IMPORTANT:
Remove the vinyl cover
or the entire sunshade before transport
in an open truck or trailer.
Figure 2
3
