Function Setting
功能設定
Ceramic Heater
陶 瓷 暖 風 機
4
1.
小心從包裝取出暖風機。
2.
將暖風機擺放於穩固的平面上。
3.
將插頭插入電壓
220-240V
的獨立插座
,暖風機
會"嗶"聲響起,
" "鍵指示燈
不斷閃爍
,
暖風機已可使用。
The Heater may be operated by the manual controls located on the Heater.
1. Carefully remove the Heater from the plastic bag and the carton.
2. Place the Heater on a stable flat surface.
3. Plug the Power Cord into a a.c. 220-240V electrical outlet, the Heater will
have a "beep" sound" and the" " key indicator will keep flash on, then the
Heater is ready to use.
注意:第一次使用暖風機,可能會出現少量氣味約數分鐘,因本產品在生產時發熱
元件帶有一層保護油,此乃正常現象。
NOTE: For first time operation, there will have some smell for about few minutes.
Because this Heater have some protective oil on the surface of the heating.
暖風機可使用機身頂部按鍵操控。
5.
模式:按" "鍵,暖風機進入人體感應模式運作。本機前方感應器會於機前約
1
米距離內感應是否有人體移動,若於一分鐘內未能感應人體移動,本機會
於
30
秒後停止運作及進入待機狀態," "鍵指示燈閃爍。當重新感應到
有人體移動,本機會自動重新運作。
5. MODE: Press the" "key, the Heater will work in sensor mode. Sensor
4. ON/OFF: Press the" "key, the Heater will start operation at(800W),
" "key indicator will light on.
4.
開/關:按" "鍵,暖風機將以
(800W)
運作," "鍵指示燈同時亮起
。
6.
定時關機:使用" "鍵連續按下選定
3
個不同的自動關機時間,分別是
1/2/4
小時,並有指示燈顯示已選擇的時間。
6. TIMER: Press" "key continually to set desired auto power off time.
will detect any body movement in front of it within 1 meter. If no
body movement is detected or 1 minutes, the Heater will stop
working after 30 seconds and enter the standby mode, the" "
key indicator will flash on. The Heater will work again whenever
it detects any body movement.
There are 3 time intervals (1/2/4 hour), for auto power off.
The LED light indicates the time selected.