OR-7200ED User’s Manual
34
PTZ can be sync with Event using its preset function. If Event occurs, PTZ moves to the position where event and positions are pre set.
The above menu shows, Sensor 1 is set to sync to cameras 1,2,3 and 4. If you click PTZ section, PTZ preset (position) can be set for
cameras in the event of Sensor activation.
PTZ event related preset can be synch only with Sensor/Motion/Video Loss events. If there are multi events occur to a camera at same
time, it takes events in order of Sensor > Motion > Video Loss.
3.2.6.2.
MENU > EVENT > Motion
In Motion, system provides Motion Detection function. Set Motion Detection using Sensitivity, View and Area options.
Sensitivity
: Select motion sensitivity from Very Low to Very High.
Area
: Define the area for motion detection.
Press Setup under Area to define motions detection areas. The blocks indicate the area where is defined for motion detection
Select Block
: Use arrow keys to move around a box. Select individual blocks to set motion zones. Use number keys to select and
unselect blocks (When using a mouse, use a left button).
Clear Block
: Unselect all blocks inside a box
Select All
: Select blocks on entire screen.
Clear All
: Unselect blocks on entire screen.
View
: View the appearance of motion zones on screen when motions is detected.
In Record, each camera can be synchronized with single and multi motion detections
from other cameras. Press
to select cameras to be synchronized with motions
detections.
In Alarm, each camera with motion can be synchronized with single and multi alarms.
Press
to select alarms to be synchronized with cameras for motion events.
