Symptom
Probable Cause
Action To Take
Distorted output
Internal crossover not set
Readjust crossovers. Refer to the
properly for speakers
Internal Crossover Configuration
section of this guide for detailed
instructions.
Speakers are blown
Check system with known work
ing speakers and fix or replace
as needed.
Poor bass response
Speakers wired with wrong Check speaker polarity and fix
polarity causing cancellation
as needed.
at low frequencies
Crossover set incorrectly
Reset crossovers. Refer to the
Internal Crossover Configuration
section of this guide for detailed
instructions.
Impedance load at amplifier Check speaker impedance load,
is too low
if below 1
W
, rewire speakers to
achieve higher impedance.
Battery fuse
blowing
Short in power wire or
Check power and ground con
incorrect wiring
nections and replace or repair as
needed.
Fuse used is smaller than
Replace with proper fuse size.
recommended
Actual current exceeds fuse Check speaker impedance load.
rating
If below 1
W
, rewire speakers to
achieve higher impedance.
Amplifier fuse
blowing
Fuse used is smaller than
Replace with proper fuse size.
recommended
Impedance load at
Check speaker impedance load.
amplifier too low
If below 1
W
, rewire speakers to
achieve higher impedance.
Speaker is blown with
Check system with known work
shorted outputs
ing speakers and fix or replace
as needed.
Actual current exceeds
Check speaker impedance load.
fuse rating
If below 1
W
, rewire speakers to
achieve higher impedance.
18
©2004 Directed Electronics, Inc.
Summary of Contents for ORION 8002
Page 1: ......
