3
BLENDING
1. Place the blending jar on the Motor Unit from the unlock position and slightly turn the jar
clockwise until the blending jar locks into the lock position on the motor base. If the blending jar is
not or is badly positioned, the blender will not work.
2. Peeled or cored the fruit or vegetables and then cut it into small dices, put the food piece into
the jar. Usually certain amount of purified water has to be added to facilitate the smooth running
of appliance. The amount of mixture should not exceed the max level as indicated on the
blending jar.
Note: never use boiling liquids or run the appliance empty. And the blending jar cannot be
used for blending meat.
3. Replace the Jar Cover on the jar and ensure that the Jar Cover can fix with the jar securely.
4. You may add ingredient into the jar through the center opening of Jar Cover during operation,
then replace Measuring Cup if necessary. Let the tabs of Measuring Cup align with the
grooves of Top Cover, put down and turn in clockwise by 90°to lock it in place, when
disassembling, turn the measuring cup in anti-clockwise by 90°to unlock it.
5. Connect the plug to wall outlet and set Speed Selector to your desired speed. There are four setting: P, 0, 1, 2.
The 1 setting is the low speed, the 2 setting is the high speed. Turn the selector to P position and hold it to pulse
actuate motor for delicate chopping. Release it to return the 0 position. The Pulse mode allows you to create a
burst of power for quick, efficient blending.
Note: The total operating time should not more than 3 minutes.
6. Turn the Speed Selector to 0 Position once the mixture has been blended to your desired consistency.
7. Remove the blending jar from the Motor Unit (turning the jar anti-clockwise), carefully take down the Jar Cover,
then pour and serve.
CLEANING
1. Disconnect the power supply before cleaning.
2. Pour a little warm water into the jar, turn and hold the speed selector to P position for a few seconds.
3. Remove the jar and rinse and rinse under running water. Remove Jar cover and measuring cup, then immerse
the top cover, measuring cup in water and clean them with a soft brush, finally clean them with dump cloth.
Caution: the blade base can be disassembled for cleaning.
4. Wipe the outside of base with a damp cloth. Never immerse it in water as electric shock is possible to occur. Then
dry thoroughly. Ensure the interlock area is free of food particles.
CHOPPING
1.
Firstly assemble the driving shaft into the motor base, make sure it is clipped into position.
2. Place the chopping jar on the Motor Unit from the unlock position and slightly turn the
chopping jar clockwise until the chopping jar locks into the lock position on the motor base.
Make sure it is assembled in place correctly, otherwise the appliance will not operate.
3. Insert the “S” blade into the driving shaft in the chopping jar securely. Make sure it is
locked into position.
4. Then place the prepared chopping food into the jar. The food must be cut into small size
firstly (such as 2cm*2cm*6cm for beef). During chopping, you can add food through the
feeding funnel with the pusher, never using food or finger to push the food into the feeding
funnel.