Orion OXB-902, Instruction Manual

4

5. 

  Place the lid onto the jar and turn it clockwise until the tab of the lid clicks into slot in the jar handle. Make sure it 

is locked in position correctly, otherwise the appliance will not operate.   

6. 

Connect the appliance to power supply and set Speed Selector to your desired speed.   

7. 

There are four setting: P, 0, 1, 2. The 1 setting is the low speed, the 2 setting is the high speed. Turn the selector 

to P position and hold it to pulse actuate motor for delicate chopping. Release it to return the 0 position. The 

Pulse mode allows you to create a burst of power for quick, efficient blending. You can chop up to 400g of 

following foodstuff. 

Hard substance:

 cheese, dried fruits, and certain vegetables (carrots, celery…), 

Soft substance:

 certain vegetables (onions, spinach…)   

Raw and cooked meat 

(boned and sliced) 

CAUTION: The total operating time should not be more than 90 sec. 

8.  Turn the Speed Selector to “0” position and unplug the appliance after chopping. Open the top lid and grasp 

blade by its hub and remove. Unlock chopping jar by turning it in anti-clockwise away from motor base, and lift it 

off. Empty the processed food.   

CAUTION: The “S” blade is extremely sharp, handle with care. 

CLEANING  

1. Disconnect the power supply before cleaning.

2. Empty the chopping jar, dismantle all detachable parts and rinse them in warm soapy water. Extreme caution must 

be taken when handling blade as it is very sharp. All the accessories except motor base are dishwasher safe 

components, but the temperature setting shall not exceed 70

Ԩ

. Then dry thoroughly. 

3. Wipe the outside of base with damp cloth. Never immerse it in water as electric shock is possible to occur. Then dry 

thoroughly. Ensure the interlock area is free of food particles   

FOR A QUICK WASH UP   

Between processing tasks, pour in some water into the chopping jar, turn and hold the speed selector to P position a 

few seconds for quick cleaning.   

KNEADING/MIXING 

1.  Firstly assemble the driving shaft into the motor base, make sure it is clipped into 

position. 

2.  Place the chopping jar on the Motor Unit from the unlock position and slightly turn the 

chopping jar clockwise until the chopping jar locks into the lock position on the motor 

base. Make sure it is assembled in place correctly, otherwise the appliance will not 

operate.  

3.    Insert the plastic blade into the driving shaft in the jar securely.   

4.  Measure the flour with food pusher and put them into the jar. The maximum quantity of 

flour is 375g.   

5.  Place the lid onto the chopping jar and turn it clockwise until the tab of the lid clicks into 

slot in the jar handle. Make sure it is locked in position correctly, otherwise the appliance 

will not operate.   

6.  Insert the food pusher into the feeding funnel.