Setting MLCD ID configuration and Connection (3X3)
5.
Configure MLCD ID and make connections for all the
necessary external devices and power.
Configure MLCD ID as shown in the following figure.
•
Make necessary connections such as VCR, PC and power, etc and finish configuration.
•
Neatly arrange all the connection cables. If they are stretched out or disorganized, it may cause
•
personal injury or bad connection.
For more information for ID configuration and connection, please refer to MLCD user
¿
manual.
dVI
ID 1
ID 7
ID 2
ID 5
ID 4
ID 8
ID 3
ID 6
ID 9
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
DVI-D
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C control PC
dVI Signal distributor
(UXGA : UP TO 165Mhz)
This manual describes the installation for 3X3 sets.
¿
Apply following instruction according to the number of MLCD sets as you need.
WALL UNIT
25.0
40.0
429.7
40.0
545.7
40.0
545.7
40.0
55.0
50
65
223.0
1770.6
WALL BRACKET
MAIN FRAME
WALL
50mm
- 20 -
www.oriondisplay.net
- 21 -
Infinitely Expandable
MLCD
W
ALL UNIT
