Orion User Guide
Be careful not to
damage any
components during
the installation.
The hard drive
jumper settings for
IDE drives should
be master or factory
default.
Chapter 2 - Installing the HDD
Your unit may come with a pre-installed hard drive. Before
opening such an enclosure, please read the warranty and any
other notes from your vendor carefully before doing so, as this
could void your warranty.
1. Remove the2 screws on the rear panel of the enclosure.
2. Lift the cover off the body.
3. Install the hard drive and connect the cables.
Chapter 2 - Installing the HDD
Page 3
