2.5 PRECAUTIONS
2.5.1 Know your machine
Know your machine. Learn all the functions and actuating mechanisms, and familiarize where the emer-
gency stop switches are located. Learn the machines capacity and limitations, to avoid unnecessary down-
time and mechanical brake-down.
IMPORTANT: If any dangerous situations occur, shut down the power take off (PTO) right away.
2.5.2 Equipment control
Before starting up, make sure that the machine and its equipment is in place and in good working order!
See
chapter 7 "Maintenance and mechanical adjustments"
.
2.5.3 Cleaning
A good cleaning of the machine increases durability and safety. Therefore, keep all surfaces clean, remove
dirt, oil-spills and other remains.
2.5.4 Environmental protection
Hazardous waste, such as rubber, oil and other materials that could harm the environment, must be dis-
posed at approved disposal centres.
2.6 BREAK-IN PERIOD
Check
Check points
Do not run compactor at maximum capacity the first 25 hours of operation
Be observant – monitor that functions are working correctly.
Check for abnormal sounds from the machinery
Fine tune the process to be carried out so that the compactor can reach maximum capa-
city, based on material being baled.
2 SAFETY
20
Summary of Contents for MP2000-X
