IG-175-EN version 02; 17/06/2016
27
General Instructions
ekor.gid
Installation and connections
6.1.2. Cubicle-mounted
The ekor.gid-s Smart Distribution Management Unit can be
installed on any of the Substation's free walls, regardless of
the number of cubicles it contains.
Figure 6.2.
Detail of installed cubicle-mounted
ekor.gid
The ekor.gid-s unit is ready for cubicle-mounted installation,
through a system of supports which can be easily installed
and coupled to the cubicle, even in compact spaces.
The following steps must be followed for installing the
cubicle-mounted ekor.gid-s:
1. Place the supports on the cubicle, leaving them
horizontally balanced. The supports have a pair of
screws for height adjustment.
2. Bolt the supports to the side lugs of the cubicle.
3. Remove the cover from the cubicle's control.
4. Place the cabinet on the cubicle, using the cubicle lugs
on the control. Doing this will leave the ekor.gid-s on
the supports.
5. The right side of the ekor.gid-s has a window with
3 easily removable screws, to access the cabinet's
attachment point with the support.
6. The other point to bolt the ekor.gid-s is on the bottom
of the cubicle lugs, located above the motor control. It
is bolted to the cages located in the cabinet.
7. The next step is to cover the motorised control, along
with the cabinet's side cover.
8. Finally, the decorative covers should be placed on the
other cubicles.
The ekor.gid-s is therefore installed cubicle-mounted in any
position in the substation, secured at at least four points.
Summary of Contents for velatia ekor.gid
Page 31: ......