34/34
If you notice any INEFFICIENCY, even partial, of the BRAKES (accessory 861), immediately
contact the retailer where you purchased the product, who will determine whether they need to
be repaired or replaced to avoid dangerous situations that could cause accidents
Do not perform maintenance or replace parts or accessories when the user is in the de-
vice
Intensifie all checks in marine environments, clean more often, anoint the parts exposed
to salt corrosion (such as chrome, bolts and screws)
EXTRAORDINARY (OR CORRECTIVE) MAINTENANCE
EXTRAORDINARY MAINTENANCE MEANS ANYTHING DONE TO THE PRODUCT THAT IS NOT
MENTIONED ABOVE.
WE RECOMMEND THAT THE USER, RETAILER AND HEALTH FACILITIES ENTRUST ALL
EXTRAORDINARY OR CORRECTIVE MAINTENANCE TO THE MANUFACTURER OR OTHER
FACTORY-AUTHORIZED SERVICE CENTRE.
ANY OTHER SOLUTION WILL RESULT IN THE USER AND THE THIRD-PARTY MAINTAINER
FULLY RESPONSIBLE FOR THE RESULTS OF THEIR WORK AND THE MANUFACTURER WILL
ONLY BE LIABLE FOR ORIGINAL DEFECTS OF MATERIALS OR WORKMANSHIP.
If the product is to be disposed of, it must be done according to the law in the country of
destination
CUSTOMER SERVICE AND SPARE PARTS. REUSE
Only contact the retailer where you purchased the product for service and replacement parts.
REUSE
STANDY is suitable for reuse on the condition t hat it is accomp anied b y the use and maintenance
manual. In the absence of the m anual, request one from the retailer who supplied the pr oduct or di-
rectly from Ormesa S.r.l.
before using a previously used product:
a) become familiar with its functions. If you are not familiar with the product, read the instructions be-
fore reuse;
b)
clean the product following the instruction given on pages 33-34 of this manual.
Summary of Contents for STANDY 3
