4
OPERATING
1.
The product is an individual wireless power socket. It can be assigned to
one button (A, B, C) of the remote control which corresponds to one device
connected to that socket. You can use the remote control to control (turn
on and off) a device directly connected to that socket.
2.
One transmitter (remote control unit) supports up to 4 receivers (wireless
sockets).
LOGOUT
MAINTENANCE AND CLEANING
1.
Press and hold for about 3 seconds (but less than 6 sec.) to activate the
pairing button of the socket. Then press the OFF button (A, B, C) on the
right side of the remote control, the LED indicator will blink quickly and
then turns off. This means that the receiver has been logged off
successfully.
2.
Press and hold the pairing button for more than 6 seconds to remove all
pairing records of the receiver.
1.
Before any maintenance make sure that the power has been switched off.
2.
The device should be cleaned with soft and dry cloths only.
3.
Do not use chemical cleansers.
4.
Do not install the device close to any sources of heat.
5.
The product has an earthing pin.
TECHNICAL DATA
Power source:
receiver AC230V, 50Hz,
remote control (transmitter): 1x3VDC (battery CR2032 included in the set)
Frequency:
433MHz
Max load:
3000W
Protection level:
IP20
Range:
max. 30 m in open air
Number of channels (remote control):
4
Dimensions of socket:
55 x 55 x 80 mm
Type of socket:
French (Type E)
Simplified declaration of conformity
Orno-Logistic Sp. z o.o. declares that the products: OR-SH-1732
– wireless power socket is compatible with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following Internet address: www.orno.pl