Upon completion of the GNSS survey the GNSS receiver will lock-in the calculated GNSS
position and will enter
Standard Mode
. Once in
Standard Mode
, the GNSS survey will
only be performed again if:
the unit is halted or rebooted (see
"Performing a GNSS Receiver Survey" on
).
the equipment will be relocated to another location and the receiver detects this
(applies to most Trimble receivers)
you manually delete the GNSS position, see
"Deleting the GNSS Receiver Position"
In the event that VelaSync cannot complete a GNSS survey within 24 hours (e.g., the sur-
vey progress does not go beyond 99%), see
"Single Satellite GNSS Receiver Mode"
Single Satellite GNSS Receiver Mode
The
Single Satellite Mode
is designed for use cases in which it is
not
possible for the
GNSS receiver to track at least
four GNSS satellites
for at least
33 minutes
continuously
in a 12-hour time window so as to complete the GNSS survey, i.e. obtain a 3-D fix. In such
cases, VelaSync cannot operate in
Standard Mode
. This occurs frequently in areas with lim-
ited view of the sky (e.g., "urban canyons").
In Single Satellite Mode, the GNSS receiver will be considered a valid input reference as
long as:
a.
the receiver was able to
complete a survey
during a time window with good satellite
reception, OR you have manually entered a valid position for your antenna location
(instructions can be found under
"Manually Setting the GNSS Position" on
"Determining Your Position" on page 139
.)
b.
the GNSS receiver continues to track at least
one qualified satellite
.
Note that VelaSync is designed to provide the most accurate time in
Standard Mode
,
hence the Single Satellite Mode should only be used if the GNSS receiver could not com-
plete a survey. Note also that Single Satellite Mode can only be used if the VelaSync unit
remains stationary at all times.
Mobile GNSS Receiver Mode
In
Mobile Mode
no surveys
will be carried out since the position status is updated in near
real-time. VelaSync will go into synchronization shortly after beginning to track satellites.
The
Mobile Mode
should only be selected if your VelaSync unit will NOT remain stationary
at all times, i.e. instead of being operated in a building, it is installed in a mobile platform
(such as a vehicle, ship, plane, etc.).
3.3 Managing References
CHAPTER
3
•
VelaSync 1232 User Manual Rev. 4
131
Summary of Contents for Spectracom VelaSync 1232
