1.2
Connectors and their Pinouts
All of VersaSync's connectors are provided at the front panel of the unit, below the Status
LEDs.
1.2.1
Power Connector
Note:
View in mating direction from front.
Table 1-3:
Power connector pinout
Pin
Signal
1
V
Main
(10 to 32 V)
2
-not used-
3
V
Standby
(10 to 32 V)
4
GND (to Standby)
5
GND (to Main)
This product is designed to handle a
maximum voltage of up to 32 V
DC
. Power supplies
with higher voltage or transient/ cranking power will require a power conditioner or surge
blocker.
Caution:
Reversed polarity can blow an internal fuse that protects the
product from damage. Use care when building power cables.
1.2 Connectors and their Pinouts
VersaSync Getting Started Guide Rev. 8
3