WARNING
Sensor Switches
MODEL
DWOS
WARNING — T
URN OFF THE CIRCUIT BREAKER BEFORE INSTALLATION.
1. The SENSOR SWITCH is for INDOOR USE ONLY
2. Do not exceed electrical ratings
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
info@ortechindustries.com
www.ortechindustries.com
375 Admiral Blvd
Missisauga
,
ON L5T 2N1
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMECING INSTALLATION AND RETAIN FOR FUTURE
REFERENCES. Electrical products can cause death or injury, or damage to property. If in any doubt
about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
1.
Connect lead wires as shown in WIRING DIAGRAM (see fig.
2
): Black lead to Line (Hot), Red lead
to Load wire, White lead to Neutral wire, Green lead to Ground
2.
Gently position wires in wall box, attach sensor switch to the box
3.
Mount device "TOP" up
4.
Restore power at circuit breaker or fuse, wait ONE minute
5.
Remove the small cover plate (see fig.
1
)
6.
Locate the adjustment knobs on the control panel to perform test and adjustment (see fig.
1
)
7.
Replace the small cover plate after testing and adjustment
8.
Attach the wallplate
fig.2
fig.1
OPERATION
The Sensor Switch is programmed independently for either
Occupancy
Mode or Vacancy Mode depending on the Band
Switch position under
the control panel cover. Some might
call the Vacancy mode as "Manual
On Occupancy Mode"
.
Manual ON/OFF Button
By Pushing the Control Panel Cover, the Load can be turned ON/OFF under either OCC or VAC mode (see fig.
3
)
Turning On the Load under Occupancy Mode
Load automatically turned ON when occupancy is detected
Turning On the Load under
Vacan
cy Mode
Manual ON/OFF Button has to be pushed to turn ON the Load
Automatic Turning OFF the Load
Under either mode, the Sensor keeps the Load ON until no motion is detected plus the set time delay, then turns OFF automatically. Under VAC
mode, the Load can turn ON automatically if motion is detected within the first 30 seconds
Manual Turning OFF the load
By Manual ON/OFF Button, the Load can be turned OFF under either OCC or VAC mode. Under OCC Mode, if you press manual ON/OFF button
first, the sensor switch returns to normal until set-time finished
fig.3
NOTE:
For DWOS, there is night light behind the Fresnel Lens as follows:
OFF — The Night Light keeps on constantly
OCC — The Night Light will not work
VAC — The Night Light will turn ON under occupancy when load is off. Conversely, the NIGHT LIGHT will turn OFF when load is ON
