INSTALLATION GUIDE
Compact Series
MODEL
OD
C-1008 | ODC-8003
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
info@ortechindustries.com
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Connect Electrical Wiring
Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house
wiring to the wiring plate. Refer to the wiring diagram below, and connect the wires as shown.
Install Grille
Install ceiling material to complete the ceiling construction. Then, cut around the
fan housing.
To attach the grille assembly to the fan housing, pinch the grille
springs on the side
s
of the grille assembly, and position the grille into the
housing with the grille springs in the appropriate slots.
Push the grille assembly
towards the ceiling to secure.
Service Parts
* Blower Assembly includes
*
part 3, 4, 5, 6, a, b
* Replacement Installation:
*
Remove the screw (part
*
a), then take out the
*
blower assembly from
*
the housing (part 7).
*
Replace the broken parts.
WARNING:
Ensure that the fan is switched OFF
from the supply mains before replacing.