ODDMF Inline Fans
MODEL
ODDMF-
6-350 | ODDMF-8-710 | ODDMF-10-1065 | ODDMF-12-1750
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
info@ortechindustries.com
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
OPERATION
WARNING!
MUST CONNECT SECURELY TO SPEED CONTROL BEFORE POWER UP
DO NOT deform fan bracket or fan housing
DO NOT install fan on sheet rock or weak surface
Always install the fan at the height of 2.1m or above
Unpack and check fan for damage. Ensure that the fan impeller
spins freely and not touching fan housing.
Use a pre-filter on the absorption axis to prevent dust, oil and
other foreign substances from building up on the impeller.
Build up of dust and or foreign material can cause out of balance
impeller and excessive vibration.
Excessive vibration will reduce fan lifetime.
INSTALLATION GUIDE
Use the appropriate attachment screws for the surface material
being selected to mount the fan.
Use the supplied mounting bracket or hanger.
After completing the installation, electrical work and duct work,
perform the test operation to confirm if the fan operates normally
After turning the power on, the fan should rotate freely,
and build up speed normally
If there is abnormal noise or no rotation,
check all connections as well as power supply
Wall Mounted Installation
Mark the screw position
on the wall
Punch holes in the wall
Screw the fan onto the wall
Connect the ducts onto
two sides with clamps
Connect the speed control to the
fan and make sure the connection
is in place and fastened
Power up the fan
Hang Installation
1
2
3
4
5
6
