HOW TO CHARGE BATTERIES
• Check that the ventilation slots on the charger are clean and
unobstructed.
• Plug the charger output lead into the socket on the joystick control
box.
• Do not use your EP1C wheelchair while charging is in progress.
• Disconnect the charger completely before using your chair again
before use.
When charging is complete switch off and disconnect from the mains. If
required, the charger can be left connected to the powered wheelchair and
to the mains. This will keep the batteries 100% charged and compensate for
self-discharging over a long period. (You cannot overcharge your batteries).
• Connect the charger power supply cable to the mains socket and
switch the power on. The ‘Mains ON’ and the ‘Charging’ lights on the
charger will come-on.
• It is recommended the charger is left connected as described until
the ‘Full Charge’ light illuminates to obtain optimum performance of
the batteries...
• When the ‘Charge Complete’ light illuminates, the batteries are fully
charged and ready for use.
DISPOSING AND RECYCLING OF USED BATTERIES
You can help preserve our environment by returning your used rechargeable
batteries to the collection and recycling location nearest to you. Batteries
must always be correctly recycled. Under no circumstances should batteries
be disposed of in domestic refuse.
Permanent magnet DC EP1C MOTOR
TECHNICAL OPERATING INSTRUCTIONS
The motor on your EP1C chair is made by Motion Tech and are CE certified,
built of high quality components and assembled under strict quality system
approved by ISO-9001. Before using Motion Tech’s products, please read
these operating instructions carefully.
45