4 ADJUSTMENTS
Inc. All rights reserved
22
4.3.3. INSTALLING A BOLTED TENSION BAR WITH HEAD SUPPORT
ANCHOR.
Figure 8-A: Tension bar.
Figure 8-B: Cutting the rubber
A tension bar can be installed on the
Tango AC and Tango
CE
to accommodate a head
support.To do this:
1. Cut the rubber end of the back support posts to uncover their ends (see Figure 8-B).
2. With a
5/32 in. Allen wrench
, tighten the screw (
A
) at each end of the tension bar to
the end of the back support posts, which you just uncovered in step 1 (see Figure 8-
A).
3. Firmly tighten the screws (
A
).
4.3.4. ADJUSTABLE ANGLE ELEVATED PUSH BAR
Figure 9-A: Adjustable angle elevated push bar.
