4 ADJUSTMENTS
Inc. All rights reserved
30
Table 2: Configuring the Tango 6-wheel tilt wheelchair
To obtain the floor-to-seat height values in this range, the wheel axle must be installed in
the L1 position. At all other times, the axle must be in position L0 (see Figure 11-C).
Always follow the front and rear wheel combinations in Table 2
to ensure stability of the tilt wheelchair.
Figure 11-C: Position of the drive wheel axle
Position of the wheel
axle
Only 5 to 20 in.
L0
L1
Position of the
standard wheel
axle
Note:
1:
Depending on the type of arm support,
positioning of the drive wheel axle (rear), and
floor-to-seat height, there may be some
interference that reduces the tilt angle.
2:
Pos1 to +5 (4-wheel Tango AC) and
the central position (6-wheel Tango AC) are for
reference only. Any adjustment can be made
between them. Simply use the positioning
indicator and position the wheel axle at the
desired location, then repeat the same on both
sides of the wheelchair.
