4 ADJUSTMENTS
Inc. All rights reserved
47
d) Tango 6-wheel brake adjustment
Figure 21-A: Brake position adjustment.
1. Adjustment for 20, 22 or 24 in. drive wheel position (see Figure 21-B
and Table 2):
Once the position of the rear wheels is set (see Figure 21-B), you must reposition
the brake support.
2. Loosen the screw (
B
) with a
7/16 in. open-end wrench
. The brake support can now
be slipped into position.
3. Depending on wheel diameter or interface height, you may have to reverse the
direction of the brake support or adjust its height. To do so, unscrew the screws
(
A
) and the nuts (
B
) with two (2)
7/16 in. open-end wrenches
and invert the brake
support, or simply change its height by positioning it in the additional holes.
4. You can also swap the left and right cylinder if it allows easier positioning of the
brake, or you can position it in the interface holes.
Brake support
Additional positioning
hole
A
B
Interface hole
