5 USE
Inc. All rights reserved
72
Section 1
– General information
•
The impact tests were conducted with a dummy restrained by pelvic and shoulder belts,
and both should be used when the wheelchair is used as the seat in a motor vehicle.
•
The shoulder belt, not supplied by
, must comply with Section 5.1 of ISO-
7176-19 and be labeled as such.
•
A four-point (4) or base anchor system should be used to secure the wheelchair in a
motor vehicle (check compatibility of the base anchor system with ORTHOFAB).
•
Ease of access and maneuverability in motor vehicles can be significantly affected by
the wheelchair's size and turning radius. Smaller wheelchairs with a smaller turning
radius will dramatically improve ease of access for positioning a wheelchair forward in a
motor vehicle.
•
Removable components and/or accessories should be secured independently.
Do not place any object near the seat belt release button to
prevent accidental release.
Do not recline the wheelchair seat angle more than 30° when
using it as a motor vehicle seat.
Do not rely on postural components to restrain the occupant
in a moving vehicle.
Have the wheelchair
inspected for damage if it is involved in a
sudden stop. Replace any wheelchair that is involved in a
collision.
Do not use the tilt function during transport to avoid changing
the tension of the tie-down straps.
