1. General
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastr.11 • 73119 Zell unter Aichelberg • Germany
5
Tel.: +49 (0) 7164 79701-0 • Fax.: +49 (0) 7164 79701-51 • e-mail: info@ortlieb.net • www.ortlieb.net
1.3 Intended Use
Use the tool-grippers only for the intended use. Insufficiently clamped tools or work-pieces, failure
to comply „safety and accident prevention regulations“, and the use of work-pieces and our
products on machines that are not intended for this propose, can result in personal injury and
damages to the clamping devices. In this case, we shall assume no liability. Do not apply force
during assembly, disassembly and operation; this could damage the clamping device or the
machine.
1.4 Initial start-up
A function check is implicitly before initial operation of the tool-gripper. To ensure a safe and
precise operation of the tool-gripper during machining, a sufficient clamping force must be
provided. Check the clamping force.
See: Checklist for Installation p.6
The tool-gripper, especially the function surfaces must be clean and lubricated sufficiently. It is
strongly recommended to grease with suitable assembling grease.
Never exceed the axial and radial forces specified on the tool-gripper.
Check the clamping force regularly!
