1. General
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastr.11 • 73119 Zell unter Aichelberg • Germany
7
Tel.: +49 (0) 7164 79701-0 • Fax.: +49 (0) 7164 79701-51 • e-mail: info@ortlieb.net • www.ortlieb.net
10.)
For optimal drawing-in force, RPM
max.
and n
max.
, please refer to data on the installation
drawing.
11.)
Tools must meet DIN 69871 /72 standards.
12.)
Without an HSK tool insert, there is no operation of the spindle allowed. (Out-of-balance!)
13.)
After every crash, the tool-gripper must always be exchanged completely.
14.)
The clamping force transmitted to the tool shank by the tool-gripper may not be below the
incident machining forces and torques. It is also important that the functional surfaces and
the clamping system are greased regularly (Metaflux lubricant metal paste)
Based on experience, re-greasing should be done after every 200.000 load alternations
at the least in order to keep the clamping force as uniform as possible. Regular
measurement of the clamping force, either quarterly or semi-annual, will ensure the
required safety for the work process. (See p.12)
15.)
Check the tightening of the draw-bolt and the drawbar regularly to ensure a proper
function of the tool-gripper.
A loose draw-bolt causes a loss of clamping force and ejects the tool far over the allowed
max. 1,0mm.
