35
34
5.3.2 Height adjustment
Tool:
1 x 13 mm open-end or ring spanner
Slacken the securing screw (Fig. 42/
➂
),
bring the backrest into the desired
vertical position and then retighten the
securing screw.
!
Attention:
The maximum armrest height has
been reached when the marking on
the square tube is visible.
5.3.3 Detaching the armrest
Slacken the clamping lever (Fig. 42/
➂
)
and pull off the armrest in an upward
direction.
☞
Note:
The control unit must be detached
first if the armrest on the control side
is to be detached. To do this, open
the cable clip (Fig. 43/
➃
) and slack-
en the securing screw (Fig. 42/
➀
).
Push the control unit to the rear. Slack-
en the clamping lever (Fig. 42/
➂
)
and pull off the entire armrest unit
in an upward direction.
42
1
43
4
3
2
The control unit can now be pulled out
to the front. Carefully route the cable
when moving the control unit. Retight-
en the clamping screw.
5.3 Armrests
The armrests can be adjusted in height
and depth to suit the needs of the user.
!
Attention:
Do not use the armrests to lift or car-
ry the wheelchair.
Do not drive without the armrests!
5.3.1 Adjusting to suit the seat
depth
Tool:
1 x 13 mm open-end or ring spanner
Slacken the securing screw (Fig. 40/
➀
),
bring the armrest into the desired hori-
zontal position and then retighten the
securing screw.
☞
Note:
Slacken the securing screw (Fig. 40/
➁
) to adjust the depth of the control
unit. Retighten the securing screw
after the depth adjustment.
40
1
2
