14
Dongguan Ortur Intelligent Technologies Co., Ltd.
https://ortur.tech/auferolaser1
No.1 Building, Ruijin Science and Technology Industrial Park, Changping, Dongguan 523558, Guandong Province, China
By
LightBurn
1. Launch
LightBurn
software;
Note:
We would recommend updating to the latest version as well. Lightburn
1.0.06 is the latest version at the time of writing of this guide
2. Select the appropriate serial port for your
Aufero Laser 1
and wait for the
Connection
status
“READY”
;
3. Once connection is established, console window will show the welcome
message. If Console is not visible go to Window menu - Console.
4. Confirm that the welcome message shows [
OLF 187]
as latest firmware. This
confirms the update procedure was successful.
5. Below console window, where
LightBurn
has a input box saying (type
commands here) enter the following command:
$RST=*
and press the
Enter
key;
