2
7
SAFETY INSTRUCTIONS
ALSO AVAILABLE FROM OSAKI
Osaki Power Tools are committed to the Production of Quality Power Tools
that are designed for high performance and long service life.
If safety and maintenance procedures are observed they will last for many years.
115mm
Angle Grinder
Multi Purpose
Power Tool
Delta Sander
Orbital
Sheet
Sander
Orbital
Jigsaw
160mm
Circular
Saw
12, 14.4
& 16.8 Volt
Cordless
Drill/Screwdrivers
Man, Earth and the Universe
are forces that create an
immovable centre of balance . . .
the
balance of power
“
”
GENERAL SAFETY
l
To reduce the risk of injury, close supervision
is necessary when a product is used near
children. Do not allow the pressure washer to
be used by children or people who are not
familiar with it.
l
Know how to stop the product and bleed the
pressure quickly. Be thoroughly familiar with
the controls.
l
Stay alert and watch what you are doing.
l
Do not operate the product when tired or
under the influence of alcohol or drugs.
l
Keep operating area clear of all people and
clutter.
l
Do not over reach or stand on an unstable
support. Keep a good footing and balance at
all times.
l
This product must be grounded.
l
When working outdoors only use suitably
approved extension cables with a minimum
conductor cross section of 1.5mm
2
. The plug
connectors must have earthing contacts and
be waterproof.
l
Do not start and run the machine in the rain
or stormy conditions. Keep all connections
dry and off the ground. Do not touch the plug
or sockets with wet hands. It is very
important not to let water leak into the
machine.
l
The machine should be switched off if it is
not used for periods longer than 3 minutes.
l
Maintain a constant water supply when the
machine is running. Without water circulation
damage will be caused to the sealing rings of
the machine.
l
It is necessary to turn on the spray lance
within one or two minutes after the machine
has been started. Otherwise, the
temperature of the circulating water within
the machine will soon rise to a critical point,
which will cause damage to the sealing rings
inside the machine.
l
Do not start and run the pressure washer in
a place which is excessively cold.
l
This device has been designed for only using
cleaning water. Do not use corrosive
chemicals.
l
Hold the spray lance firmly when in use as
there is a chance it might swing back with
the force that is inside it.
l
Do not use the appliance within the range of
persons unless they are wearing protective
clothing.
l
Do not wash any objects which are a health
hazard e.g. asbestos.
l
High pressure jets can be dangerous if
subject to misuse. The jet must not be
directed at persons, live electrical equipment
or the appliance itself. Pressure washers
should not be pointed less than 30cm away
from tyre walls or tyre valves, as it may be
possible to damage them.
l
Do not direct the jet against yourself or
others in order to clean clothes or footwear.
l
Disconnect from the electrical power supply
before carrying out user maintenance.
l
To ensure the appliance safety, please use
only original spare parts from Osaki. Do not
use the machine before you have changed
them if they are damaged.
l
Stay alert at all times. Watch what you are
doing and use your common sense. Do not
operate the power washer when you are
tired.
l
Store the power washer in a dry, secure
place, away from children.
