• Always be sure of your footing.
Particularly on slopes.
.
• Exercise extreme caution when changing direction
on slopes.
.
• Do not cut excessively steep slopes and always
wear non-slip footwear.
• Walk, never run.
.
• Ensure the lines have stopped rotating and
take extreme care before lifting your trimmer for
and during transportation.
.
• Never operate your trimmer with defective
guards or shields.
ELECTRICAL SAFETY
Always check that power supply
corresponds to the voltage rating plate.
DOUBLE INSULATION
Your electric tool is double insulated.
This means that all external metal parts
are electrically isolated from the power
supply. This is achieved by placing an
extra insulation barrier between the
electrical and mechanical parts. Double
insulation means greater electrical safety
and there is no need to have your
electrical tool earthed.
• Your trimmer will continue to run for a
short time after releasing the switch lever. Always
allow your trimmer to stop on its own.
.
• Release the switch to turn your trimmer off
and remove the plug from the mains:
.
- Whenever you leave your trimmer unattended.
.
- Before checking, cleaning, adjusting or
working on your trimmer.
.
- If your trimmer starts to vibrate abnormally
(check immediately).
.
- After striking a foreign object. Inspect your
trimmer for damage and make repairs
as necessary.
.
• Do not put hands or feet near rotating parts.
.
• Do not use your trimmer in the rain and do
not allow it to get wet. Avoid using your grass
trimmer in wet grass, if possible.
.
• Use your grass trimmer only in daylight or
good artificial light.
• Do not walk backwards when operating.
SAFETY
THE NUMBERS MENTIONED IN THE TEXT CORRESPOND WITH THE PICTURES
TECHNICAL DRAWINGS
• Your grass trimmer is designed for use on AC
(mains) electrical supplies only, do not attempt to
use it on any other supply.
• Never carry your grass trimmer by the cable or
jerk the cable to separate the connectors.
• Keep the cable away from heat sources, oils or
sharp edges. Check the condition of your cable
before use and do not use if damaged.
PREPARATION
• To protect your feet, always wear stout shoes
or boots-freshly cut grass is damp and slippery.
• Rubber or man-made footwear will
enhance your safety.
• Do not operate the grass trimmer barefoot or
in open sandals.
• Use protective equipment. Wear safety spectacles
or goggles whilst operating your grass trimmer.
Use ear protection if the sound level seems uncom-
fortable when using your trimmer.
• Use a face mask if the ground is dusty.
• Wear long trousers to protect your legs.
WARNING
Read this manual carefully before using the machine,
for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the enclosed
safety instructions as well as the additional safety
instructions.
Read all of this manual carefully, observing the recom-
mended safety instructions before, during and after
using your electric tool. Following these simple instruc-
tions will also maintain your electric tool in good
working order. Familiarise yourself with the controls
on your electric tool before attempting to operate it,
but above all, be sure you know how to stop your
electric tool in an emergency. Retain this user manual
and all other literature supplied with your electric tool
for future reference.
SAFETY INSTRUCTIONS
TRAINING
• Never allow children or persons who are
unfamiliar with this type of electric tool to use it,
nor anyone who has not read this user manual.
.
• Do not allow children, animals or other persons
near your electric tool when in use, always keep
them at least 6m (20ft) away from the cutting area.
.
• Remember that the operator is responsible
for accidents or hazard occurring to other people
or their property.
INTRODUCTION
INTRODUCTION
For a safe operation:
For a safe operation:
THE NUMBERS MENTIONED IN THE TEXT CORRESPOND WITH THE PICTURES
TECHNICAL DRAWINGS
THE NUMBERS MENTIONED IN THE TEXT CORRESPOND WITH THE PICTURES
TECHNICAL DRAWINGS
Connect the Blue wire to the terminal marked
Neutral (N). Connect the Brown wire to the terminal
marked Live (L). Ensure that the outer insulation is
gripped by the cord grip and that the wires are not
trapped when replacing the plug cover. The mains
lead on this product is fitted with a 13 amp (BS1363/A)
plug. A 5 amp (BS1362) fuse must be fitted in the
plug.
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN.
There are no user serviceable parts inside except
those referred to in the manual. Always refer servicing
to qualified service personnel. Never remove any
part of the casing unless qualified to do so; this unit
contains dangerous voltages.
WARNING!!
We recommend the use of a residual current
device (R.C.D.) with a tripping current of not more
than 30mA.
Even with an R.C.D. installed, 100% safety cannot be
guaranteed and safe working practice must be
followed at all times. Check your R.C.D. every time
you use it.
CONNECTION OF THE MAINS PLUG
Important!
The wires in the mains lead which are fitted to this
product are coloured in accordance with the following
code:
Brown: Live (L) or Red
Blue: Neutral (N) or Black
THIS PRODUCT IS DOUBLE INSULATED AND
THERFORE DOES NOT REQUIRE A CONNECTION TO
EARTH. 3 PIN PLUG MUST COMPLY TO BS1363/A.
FUSE MUST COMPLY TO BS1362.
If for any reason the 13 amp plug fitted to this product
requires replacement it must be wired in accordance
with the following instruction.:
DO NOT CONNECT THE BROWN LIVE OR BLUE
NEUTRAL TO THE EARTH PIN MARKED E ON
THE 3 PIN PLUG.
ELECTRICAL INFORMATION
INTRODUCTION
(fig.1)
(fig.2)
(fig.4)
(fig.3)
(fig.5)
(fig.6)
(fig.9)
(fig.7)
(fig.8)
• Always be sure of your footing.
Particularly on slopes.
.
• Exercise extreme caution when changing direction
on slopes.
.
• Do not cut excessively steep slopes and always
wear non-slip footwear.
• Walk, never run.
.
• Ensure the lines have stopped rotating and
take extreme care before lifting your trimmer for
and during transportation.
.
• Never operate your trimmer with defective
guards or shields.
ELECTRICAL SAFETY
Always check that power supply
corresponds to the voltage rating plate.
DOUBLE INSULATION
Your electric tool is double insulated.
This means that all external metal parts
are electrically isolated from the power
supply. This is achieved by placing an
extra insulation barrier between the
electrical and mechanical parts. Double
insulation means greater electrical safety
and there is no need to have your
electrical tool earthed.
• Your trimmer will continue to run for a
short time after releasing the switch lever. Always
allow your trimmer to stop on its own.
.
• Release the switch to turn your trimmer off
and remove the plug from the mains:
.
- Whenever you leave your trimmer unattended.
.
- Before checking, cleaning, adjusting or
working on your trimmer.
.
- If your trimmer starts to vibrate abnormally
(check immediately).
.
- After striking a foreign object. Inspect your
trimmer for damage and make repairs
as necessary.
.
• Do not put hands or feet near rotating parts.
.
• Do not use your trimmer in the rain and do
not allow it to get wet. Avoid using your grass
trimmer in wet grass, if possible.
.
• Use your grass trimmer only in daylight or
good artificial light.
• Do not walk backwards when operating.
SAFETY
THE NUMBERS MENTIONED IN THE TEXT CORRESPOND WITH THE PICTURES
TECHNICAL DRAWINGS
• Your grass trimmer is designed for use on AC
(mains) electrical supplies only, do not attempt to
use it on any other supply.
• Never carry your grass trimmer by the cable or
jerk the cable to separate the connectors.
• Keep the cable away from heat sources, oils or
sharp edges. Check the condition of your cable
before use and do not use if damaged.
PREPARATION
• To protect your feet, always wear stout shoes
or boots-freshly cut grass is damp and slippery.
• Rubber or man-made footwear will
enhance your safety.
• Do not operate the grass trimmer barefoot or
in open sandals.
• Use protective equipment. Wear safety spectacles
or goggles whilst operating your grass trimmer.
Use ear protection if the sound level seems uncom-
fortable when using your trimmer.
• Use a face mask if the ground is dusty.
• Wear long trousers to protect your legs.
WARNING
Read this manual carefully before using the machine,
for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the enclosed
safety instructions as well as the additional safety
instructions.
Read all of this manual carefully, observing the recom-
mended safety instructions before, during and after
using your electric tool. Following these simple instruc-
tions will also maintain your electric tool in good
working order. Familiarise yourself with the controls
on your electric tool before attempting to operate it,
but above all, be sure you know how to stop your
electric tool in an emergency. Retain this user manual
and all other literature supplied with your electric tool
for future reference.
SAFETY INSTRUCTIONS
TRAINING
• Never allow children or persons who are
unfamiliar with this type of electric tool to use it,
nor anyone who has not read this user manual.
.
• Do not allow children, animals or other persons
near your electric tool when in use, always keep
them at least 6m (20ft) away from the cutting area.
.
• Remember that the operator is responsible
for accidents or hazard occurring to other people
or their property.
INTRODUCTION
INTRODUCTION
