6
51
50
5
7
3
4
1. Cut the connecting wire and the air pipe tie fixed on the front sealing plate first.
2. Connect the connecting wire and the air pipe and the leg joint in the hole of the front
sealing plate, and confirm whether the docking is in place, and then insert the
docking cable and the air pipe inward from the front sealing plate hole, and insert it
under the frame, and pay attention to Avoid obstruction of the trachea when
inserted.
1
2
5. Then hang the lower leg (left and right shaft) into the frame support hinge plate
(Figure 5).
6. Cover the rotating shaft cover, press the calf to rotate the outer sleeve, and then
use the 4# hex wrench provided to tighten 2 M5×14-12.9 black zinc environmental
protection hexagon socket head cap screws and a 6×12× 1.5 Black zinc
environmental protection flat pad locks the calf support rotating cover and the calf is
installed (Fig. 6).
9.Nine, calf installation instructions
Method of usage
Method of usage
3.Insert the rotating inner sleeve and the rotating outer sleeve into the left side of the
calf and the right side of the lower leg (note: the large step must face inward).
4.Open the calf support hinge cover on the left and right mounts of the massage
chair.
7.After the screw is locked, the rear slot of the calf cover is snapped into the pin
shaft, and then the front end of the lower leg cover is pressed down and the
rotating shaft cover is pressed. completely parallel and parallel, then use the M4
screw to lock the calf rotating shaft cover and the calf is installed.
