I
PREPARATION BEFORE USING
Move method
►
There are moving rollers at the bottom of the chair.
►
Be sure the barest is at the full upright position before attempting to move
be sure to turn off from the switch in the back and remove from the power
outlet Lift the front part of the chair as showed in the figure( one person
raise the front part firmly grabbing the backrest handles, another person
push the chairwhen holding the top of the chair), move the chair by the
rollers.
DO NOT ROLL THECHAIR ON SOFTENGJNEERED WOOD OR ANY
OTHESOFTSURFACES
A
Caution
►
Don't move the chair when there is people in it.
►
Don't grab on the armrest or other parts to move the chair other than
the footrest ad backrest when moving. See picture above.
Turn on powersupply
►
Located on the side bottom ofthe chair is the power switch.
►
When plugging in to a 3 pronged certified outlet be sure the switch is
off.
A
Caution
►
Before switching on the chair, please make sure there is no damage on the
power cord and other exposed wires.
►
Make sure the power switch is off before the chair is connected to
electricity. Be sure all prongs are in good condition.
- - - - - - - - - - - - - - - - < 1 6 1 - - - - - - - - - - - - - - - -