37
36
3.Hold the armrest with both bands and insert the middle hook of the armrest into
the massage chair frame(Figure 3).
4.Align the limit hole of the armrest assembly with the wire inserted with the limit
post of the backrest and insert the armrest(Figure 4).
5.Fix the back end of the armrest with two M6 screws(Figure 5).
6.Fix the front end of the armrest with two M6 screws which has inserted the front
end hook of the armrest into the front end square opening of the massage frame in
the second step(Figure 6).
7. Align the buckle on decorations with the corresponding buckle seat of the armrest
and tighten it(Figure 8).
Method of Usage
Method of Usage
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
VII. Installation Instructions for Armrests
1.Unpack the two packages. Lift out the massage chair and armrest components.
Carefully check the accessories and appearance for any damage. Then assemble
them with a Phillips screwdriver. Then find the supplied power cord and remote
controller from the package. Firstly, insert the remote controller into the front
socket on the right side of the massage chair and tighten it (Figure 1); then plug in
the power cord, and turn on the switch to power on. At this moment, the massage
chair will start the automatic recovery action. After it is changed from the lying and
packing state to the standing standby state, unplug its PUS for assembly
.
2.Raise the rear end of the armrest,respectively insert the plug and trachea
corresponding with the same mark on the rear end of the armrest with the
connecting plug and trachea at the back of the backrest,and the match should be
in place and firm(Figure 2).
VIII
.
Installation Instructions for Legrest
·
After connecting the wires and the air hose between the legrest and the massage
chair, remove the cable ties and insert the connecting part into the seat (Figure 1).
·
Place the round tubes on the left and right sides of the legrest onto the legrest
support (Figure 2)
1
2
