39
38
Method of Usage
Method of Usage
IX
. Instructions for Removal and Use of Head Cushion and Backrest
X.
Floor Protection
·
The prolonged heavy pressure on the massage chair may cause scratches on the
floor. Thus, put a carpet or cushion on the floor where the massage chair is placed
to avoid this damage.
Note: Do not move the massage chair with its wheels on the rough ground or in a
narrow space. At least two persons are required to lift it. During lifting, take the
legrest sealing plate and backrest cover grooves as the acting points. (Do not lift the
armrest directly.)
XI
. Instruction for Movement
·
When moving the massage chair, make sure that all the wires are pulled out of
the massage chair surface; two persons must work together to move the
massage chair. There should be one person respectively in front of and behind
the massage chair. The person in front of the massage chair should lift it, while
the person behind it should push it downward. When the center of gravity of the
massage chair is completely on the base wheels, you can push the massage
chair forward to a suitable position and then gently restore it to the normal angle.
(Note: During movement, you must turn off the power switch first and then
unplug the power cord and the remote controller connection wire.)
Warning : The rear moving wheels of the massage chair are only suitable for short-
distance and slow movement. For long-distance transportation, please use other
auxiliary moving tools to move this massage chair!
3
4
·
Next, turn the legrest fixing cover over to cover the round tubes on both sides of
the legrest (Figure 3).
·
Fasten the legrest to the massage chair with two M5 screws (one on each side).
Check whether there is any abnormality during turning up and down, or any tube,
cable or wire is folded. If everything is OK, the legrest is installed (Figure 4).
Lift up
Press down
2
1
2
Zipper
Zipper
·
The use of the head cushion can reduce the intensity of kneading massage on
the neck and shoulders. You can decide whether to use the head cushion
according to your own needs (the head cushion is recommended). The backrest
and the back cushion are connected by a zipper (1). The head cushion and the
backrest are also connected by a zipper (2).
