LMW-230 SERIES LCD MONITOR User Manual
- 25 -
422/SIV422//TSL
y
STANDARD:
Use the Standard setting to
control tally via contact closure on GPI tally.
y
IMAGE VIDEO HW:
Use the Image Video
HW setting to control Image Video tally states via
contact closure on the GPI tally interface. Contact
closure of the Red pin corresponds to the left
Tally, and the Green pin maps to right Tally.
Contact closure (ground) corresponds to a LOW
state, and open circuit corresponds to a HIGH
state. This mode requires to the UMD tally mode
parameter to be set.
y
IMAGE VIDEO 422:
Use the setting to
control tally state via 422 port. GPI toggle is no
available.
y
STIV422:
OSD and LED tally
setting are the same as STANDARD and IMAGE
VIDEO 422. This mode requires to the UMD tally
mode parameter to be set. User can set the OSD
tally level via 422 port.
y
TSL:
Use the TSL 422 setting to control OSD
and LED tally via the TSL serial protocol.
CONTROL
The CONTROL menu is used for setting the key inhibit function.
Sub Menu
Settings
Explanation
CONTROL
-KEY INHIBIT
OFF/ON
Inhibit all keys except power and menu keys
If the key inhibit has been turned on, when you press any of the buttons except power and menu, the
prompt box will display on the screen as follows, and the other button functions are not valid. (Only if the
Menu button is pressed,
∧
(up),
∨
(down) and Enter button will be valid. )
KEY INHIBIT
The only menu setting can be changed when the key inhibit is engaged is the KEY INHIBIT ON/OFF
item. To change any of the items, turn the key inhibit to OFF first.
