Operating instructions EUROTRONIK-20 Page: 13
Servomotor
This line shows whether the servomotor in the EUROTRONIK to turn the 6-way valve is on or off.
The following displays are possible:
Act.motor: OFF
The servomotor is off.
Act.motor: UP
The servomotor lifts the valve disk or turns it into the next position.
Act.motor: DOWN
The servomotor lowers the valve disk.
When the servomotor is shown in the
top
line of the service terminal, it can be switched on or off:
1. The following display appears after pressing the key
:
Act.motor: OFF
Manual control
of drive
(6-way-valve)
2. The valve disk can be lifted and turned with the key
. Renewed pressing of the key
switches the
servomotor off again.
3. The valve disk can be lowered into one of the valve positions with the key
. The motor is switched off
when the bottom final position is reached or the key is pressed again.
4. The normal diagnostics display reappears when the key
is pressed again.
Note!
The drain of the swimming pool must be installed in such a way that the pipe is
higher than the water level at least at one point. A suitable ventilation valve must
be installed at the highest point. The function of this ventilation valve is to
ventilate the drain pipe whenever the filter pump is not in operation. This then
prevents unnecessary water loss in the event of a leaking multiple-way valve.
These installation and operating instructions must be observed.
We wish you lots of fun and relaxation in your swimming pool.
Further information can be found on the Internet at the following address:
https://osf.de/download/documents/documents.php?device=Eurotronik-20
Hansjürgen Meier
Elektrotechnik und Elektronik GmbH & Co KG
Eichendorffstraße 6
D-32339 Espelkamp
E-Mail: info@osf.de
Internet:
Subject to changes
04/2021
Summary of Contents for 3104811211
Page 14: ......
